Banner SureCross DX80 Wireless Networks - Manual (Page 32)

rule to the bottom of the list, increase the num-
ber of rules or maps enabled.
Local
Register The data in the local register is multiplied by
the scale factor, then written to the remote reg-
ister.
Name The name is optional and used only for display
purposes. The name acts as an identifier for a
specific register map. Type in the name in this
screen.
Prev and
Next If there are more than 16 devices or rules/
maps, use the Prev and Next buttons to dis-
play the next screen of information.
Remote
Register
Format Select the format of the remote register from
integer, unsigned, double, float, or bit. An inte-
ger is a 16-bit (signed) number, an unsigned
format is a 16-bit unsigned number, a double
refers to a double precision (32-bit) value, a
floating value is a floating point number, and a
bit value is a single bit that can either be a 0 or
a 1 (discrete value.)
Remote
Register
Number The Remote Register entry is the register be-
ing written to in the map.
Remote
Slave ID
(Unit #) The Remote Unit number is the slave ID of the
remote unit to be written to.
• Coil (output). 1xxxx, Other slave devices,
write only, 1 bit
• Discrete Input. 3xxxx, Other slave devices,
read only, 1 bit
• Input Register. 3xxxx, SureCross™ slave
devices, read only, 16 bit
• Holding Register. 4xxxx, SureCross slave
devices, read/write, 16 bit
Selecting None for remote type negates the rule
though it remains in the list until deleted. Unused
rules at the end of the list always show None as
the remote type. To prevent these from display-
ing, reduce the number of maps enabled on the
expanded view screen.
Scale The raw data in the local register is multiplied by
the scale factor to produce the data written to the
remote register.
Swap-
ped Check the Swapped box to swap the byte orien-
tation.
Update Clicking the Update button sends information to
the Ethernet Bridge or GatewayPro or retrieves
information depending on which checkboxes are
selected: Change or Get/Send All. Updating in-
formation does not save configuration informa-
tion permanently to the XML file.
Expanded RTU Write Map
Like the RTU Read Map expanded view, the RTU Write Map expanded view contains some of the same parameters as the RTU Write
Map primary view in addition to a few more parameters.
Refer to the Expanded RTU Read Map section for more information about these parameters ( GUID-5EBD5A53-1BF9-4F16-
B92D-60E91D2E058C.xml ).
SureCross Web Configurator
32 www.bannerengineering.com - tel: 763-544-3164 rev. -