Banner SureCross DX80 Wireless Networks - Manual (Page 5)

IMPORTANT! Verify the new IP address is correct before cycling power to the device. After the IP address changes, you must use the
new IP address to access these configuration screens. Print this page and file for your records.
Selecting a Host Communication Protocol
By default the Ethernet Bridge and GatewayPro systems communicate with a host using Modbus/TCP. After establishing the IP address
of the Ethernet Bridge and host, the system is set up to use Modbus/TCP.
The system can also use EtherNet/IP™. To change the system to EtherNet/IP, follow the previous instructions regarding the device and
host IP address, and then:
1. Log in using the following user name and password. User name: root Password: sxi
2. At the bottom of the System > Setup > Network page is a checkbox to enable EtherNet/IP. Only select this box if the GatewayPro
system is running on an EtherNet/IP network. This change cannot be enabled from a login other than the “root” login.
3. After selecting the EtherNet/IP Enabled checkbox, click the Set Ports button to save any changes made to the HTTP Port, Modbus
Server Port, Telnet Port, or EtherNet/IP Enabled settings.
4. Cycle power to the Ethernet Bridge or GatewayPro to complete this update. After the device powers up, the changes should be
registered.
Get ALL
For an existing network, perform a Get ALL for the devices and save the XML file before changing any network parameters. The default
XML file stored on the Ethernet Bridge or GatewayPro may not accurately represent your configured network.
SureCross Web Configurator
rev. - www.bannerengineering.com - tel: 763-544-3164 5