Banner A-GAGE MINI-ARRAY Series - Manual (Page 9)

P/N 43298 rev. E
9
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
MINI-ARRAY ®
Instruction Manual
Specifications
2. Specifications
2.1 Emitter and Receiver Specifications
Emitter/Receiver Range
9.5 mm (3/8") Beam Spacing
0.6 to 6.1 m (2 to 20') for sensors < 4'
0.6 to 4.6 m (2 to 15') for sensors > 4'
NOTE: Maximum range is specified at the
point where 3x excess gain remains.
19.1 mm (3/4") Beam Spacing
0.9 to 17 m (3 to 55') for sensors < 4'
0.9 to 14 m (3 to 45')for sensors > 4'
NOTE: Maximum range is specified at the point
where 3x excess gain remains.
Minimum Object Sensitivity
9.5 mm (3/8") Beam Spacing
19.1 mm (0.75")
Interlaced Mode: 12.7 mm (0.5")*
*NOTE: Assumes sensing is in middle
one-third of scanning range.
19.1 mm (3/4") Beam Spacing
38.1 mm (1.5")
Interlaced Mode: 25.4 mm (1.0")*
*NOTE: Assumes sensing is in middle
one-third of scanning range.
Sensor Scan Time
55 microseconds per beam, plus 1 millisecond processing time per scan. (Assumes straight scan,
continuous scan, and TBB mode; see Section 5.5.5 Scanning Modes for further information.)
Power Requirements
Emitter
0.10 amps @ 12V dc
NOTE: Maximum current is for a 6' sensor.
Receiver
9.5 mm (3/8") beams: 0.75 amps @ 12V dc max.
19.1 mm (3/4") beams: 0.50 amps @ 12V dc max.
NOTE: Maximum current is for a 6' sensor.
Connections
Emitter and receiver connect to controller using two 5-conductor quick-disconnect cables (one
each for emitter and receiver), ordered separately. See Section 1 for available cable lengths.
Cables measure 8.1 mm (0.32" ) dia., and are shielded and PVC-jacketed; conductors are 20-gauge.
• Use only Banner cables, which incorporate a "“twisted pair” for noise immunity on RS-485 data
communication lines.
• Emitter and receiver cables may not exceed 250' each.
Status Indicators
(See Section 6.1 for more
information)
Emitter
Red LED lights for proper operation
Receiver
Green: sensors aligned (> 3x excess gain)
Yellow: marginal alignment (1x-3x excess gain)
Red: sensors misaligned or beam(s) blocked
Environmental Rating NEMA 4, 13 (IEC IP65)
Construction Aluminum housing with black anodized finish; acrylic lens cover
Operating Conditions
Temperature: -20° to 70° C (-4° to 158° F)
Max. rel. humidity: 95% (non-condensing)