SARGENT Profile Series v.G1.5 Exit Devices User Manual
Page 11
Data Transfer Device Operating Instructions Section 2: DTD Setup
3. When the device manager list opens, expand Ports (COM & LPT) by clicking the + symbol. Under this is a list of the COM
ports on your PC. Look for USB Serial Port (COMx) in the list. The COM port is shown to the right. The example below
shows the DTD is assigned to COM4.
Note: If you are unsure of which device it is, unplug the USB cable and the screen will refresh. Take note of which devices
are in the list. Then plug the cable back in and notice which device re-appears in the list.
Corbin Russwin # FM 296; Sargent # A7973B Rev. 1.1
11 of 26
Important Note:
If you unplug the DTD from the USB port and plug it into a different physical port on the PC or on a
USB Hub, the COM port number will remain the same.