SARGENT Profile Series v.G1.5 Exit Devices - Manual (Page 13)

Data Transfer Device Operating Instructions Section 3: DTD Mode
3.1 IMPORT/EXPORT Menu
The IMPORT/EXPORT menu is used to export data to the door controller and import transactions from it. There are two options:
AUTO SEARCH and MANUAL SEARCH. These options are described below.
Note: The bottom line of this screen indicates which import/export option is set. Refer to section 3.2.4.
3.1.1 Exporting using the AUTO SEARCH Menu
The AUTO SEARCH option is used to communicate to a door automatically. When communications begin the DTD reads the serial
number out of the door controller and compares that to the serial numbers in the door files stored on the DTD. When it finds the
matching door file, the import/export begins. Note: If a matching file is not found, the DTD prompts you with a warning message.
When you press ENTER, you are sent to manual search mode (see section 3.1.2), where you select the door from a list.
First, enter your Comm Unlock code on your door controller, then press the ENTER button on the DTD to select AUTO SEARCH. If
communications are not established, you are prompted with the message below, which indicates you either entered the wrong code or
the DTD is not aligned properly. Press ENTER to continue.
If a matching door file is found, the following screen appears indicating the name of the matching door it found. Press ENTER to
continue the import/export process.
Corbin Russwin # FM 296; Sargent # A7973B Rev. 1.1 13 of 26