SARGENT Passport 1000 PG Cylindrical Locks - Manual (Page 10)

10 A7808B
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
10/31/12
Passport 1000 PG Cylindrical Lock
9 – Assemble Trim
1. Verify cylinder spacer is inserted into horizontal slot
of lock body.
2. Place rose scalp over shaft of lock body against
surface of door (Fig. 9A); hand-tighten (clockwise).
3. Attach lever (push until engaged).
10 – Installation of Wire Cover Plate
(Wood Door Only)
1. Align wire cover plate with chassis side against exit
chassis cover and mark hole positions.
2. Ensure stamped side of plate goes against door.
3. Drill (2) 3/32” diameter by 1/2” deep holes (Fig. 10A).
4. Cover wires with cover plate by securing plate to
door directly above rose (note orientation) using
(2) #6 x 1/2” flat head security torx wood screws (Fig.10A).
NOTE: Position lower edge of cover plate against the
rose to ensure no wires are visible (Fig. 10B).
Fig. 9A
Fig. 10A
Fig. 10B Detail
Bushing
Inside lever
Rose scalp
(2) 3/32” dia.
by 1/2” deep
holes
This side down
(2) #6 x 1/2” flat
head security
torx wood screws
Wire
cover