SARGENT Passport 1000 PG Cylindrical Locks - Manual (Page 9)

10/31/12
A7808B 9
Copyright © 2012, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Passport 1000 PG Cylindrical Lock
6 – Remove Outside Lever Only
1. Insert key, rotate 45° clockwise and hold (Fig. 6A).
2. Depress lever retainer with push pin tool (provided).
7 – Securing the Lock to Door
1. Feed wire and connector:
- For wood door, feed wires up through the
routed channel as shown (Fig. 7A).
- For metal door (not shown), feed wire and
connector through inside of door and out
hole on outside of door (not shown).
2. Attach inside rose assembly and secure
with screws, as shown (Fig. 7A).
3. Finish securing latch by tightening (2)
#8-32 x 3/4”combination screws
(see Fig. 7A & 4A).
8 – How to Change Cylinder
(If Necessary)
1. With outside lever in hand, use standard
pliers to pull out cylinder retainer.
2. Remove key and cylinder from lever.
3. Insert new cylinder.
4. Secure by pressing cylinder retainer flush.
Fig. 6A
Fig. 8A
Inside of door
Fig. 7A
Wire Harness
(From Lock body)
(2) #10-32 x 1-1/4”
Flat Head Machine
Screws (Secures
outer spring housing)
Spring housing assembly
Washers (Only 30- Prefix)
Cylinder
Outside Lever
Key
Cylinder Retainer
(2) #8-32 x 3/4”
Combination Screws