Passport 1000 pg cylindrical lock, 11 – gasket installation (optional) – SARGENT Passport 1000 PG Cylindrical Locks User Manual
Page 11
10/31/12
A7808B 11
Copyright © 2012, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Passport 1000 PG Cylindrical Lock
11 – Gasket Installation (Optional)
Note: Optional, for non-fire rated doors only.
For non-fire rated door applications, an optional gasket may be
used as a weather seal between the escutcheon and the outside
door surface.
12 – Installation of Outside Escutcheon
and Mounting Plate Assembly
1. Insert the mounting posts through holes as shown.
2. On the inside of the door, position the mounting plate over the
indicated holes.
Note: Feed controller and keypad cables through side
opening (Fig. 12A).
Cable from lock body feeds through bottom (Fig. 12A and 12B).
3. Attach grounding lug to bottom right screw and note upright
positioning of lug (Fig. 12A).
4. Insert other three corner screws and tighten, fastening the outside
escutcheon to the door (Fig. 12B).
5.
IMPORTANT: If the following step is skipped, the product
will not be UL-compliant:
Note: Peel off adhesive
backing and attach to
(outside) escutcheon
Mounting Plate
Cables
(2) #8 - 3/8” Flat Head
Wood Screws OR
(2) #8 - 3/8” Flat Head
Machine Screws
(4) #8 - 32 x 1-7/8” Flat
Head Machine Screws
Mounting Plate
Outside
Passport
Trim
Fig. 11A
Fig. 12A
Fig. 12C
Fig. 12B
Passport Gasket
Outside Passport Trim
Position lug
upright, then
tighten screw
Attach two (2) #8 x 3/8” flat head wood screws for
wood doors, or (2) #8-32 x 3/8” flat head machine
screws for metal doors (Fig. 12C).