Standard application – SARGENT 1431 Series Aluminum Closer User Manual
Page 2
2
Copyright © 1998, 2000, 2002,2005, 2207-2009, 2011, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part
without the express written permission of Sargent Manufacturing Company is prohibited.
11/01/11
A7139K
• Select closer mounting position based on the maximum door opening, as listed below
Note: For ADA applications, select the 160º position.
1
STANDARD APPLICATION
• Using the enclosed self adhesive template, locate and mark hole locations
Note: 3/32" pilot holes are required when Self Tapping Screws are being used
If machine screws are being used, use a drill #16 (.177) and a #12-24 tap
2
• Install closer body onto the door with 5/8" power adjustment nut end away from hinge
• Install foot & rod assembly onto the frames
3
** If butt, frame and wall conditions permit,
door will open 180º
Note: On the foot & rod assembly always
use the pivot farthest from the hinge
RIGHT HAND DOOR ILLUSTRATED, SAME DIMENSIONS APPLY FOR LEFT HAND DOOR.
*SEE PAGE 8 FOR MORTISE NUTS
• Install main arm on the closer with the index mark on the spindle aligning with #2 on the main arm (as shown)
4