Instructions for installing top jamb, Closer mounted on frame above stop side of door, Final adjustment and regulating procedure – SARGENT 1431 Series Aluminum Closer User Manual
Page 7
INSTRUCTIONS FOR INSTALLING TOP JAMb
Closer mounted on frame above stop side of door
• Install main arm on the closer with index mark on spindle aligned with the number on the arm
Note: Left Hand Doors – align index mark with the #3 on the main arm (as shown)
Right hand Door – align index mark with the #1 on the main arm (as shown)
• This requires the spindle to be rotated
• Rotate the spindle on the top of the closer to align index mark and the required number on the arm
4
• Opening the door slightly, slide rod into swivel arm and then
close the door
• With the door closed, position the main arm so it is at 90º to
the door surface
• Tighten the arm screw securely
5
• Adjust door speed and latching speed valves to achieve the desired closing time. Recommend 6 seconds minimum
for 90º to the closed position
• If backcheck is required, adjust valve to achieve a slight cushioning effect. Auxiliary stop required.
• If closer is equipped with delayed action, regulate valve to achieve the desired delay
6
7
A7139K - 11/01/11
Copyright © 1998, 2000, 2002,2005, 2207-2009, 2011, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part
without the express written permission of Sargent Manufacturing Company is prohibited.
FINAL ADJUSTMENT AND REGULATING PROCEDURE
Adjust closing power to the minimum required
to reliably close and latch door
• If door is hard to open, decrease power slightly
• If door does not latch, increase power as required
• Use the chart (on the left) as a starting point
• Doors adjusted with high closing power to
overcome strong draft conditions may exceed
ADA standards