Closer mounted on stop side of door – SARGENT 1431 Series Aluminum Closer User Manual
Page 5
INSTRUCTIONS FOR INSTALLING PARALLEL ARM APPLICATION
Closer mounted on stop side of door
• Install main arm on the closer with index mark on spindle aligned with the number on the arm
Note: Left Hand Doors – align index mark with the #4 on the main arm (as shown)
Right hand Door – align index mark with the #5 on the main arm (as shown)
• This requires the spindle to be rotated
• Rotate the spindle on the bottom of the closer to align index mark and the required number on the arm
5
• Opening the door slightly, slide rod into swivel arm and then close the door
• With the door in the closed position, swivel arm so that the pivot is 1-21/2" off the door surface (as shown below)
• Tighten the arm screw securely
6
“
Adjust closer as required (See page 8 for details)
7
ACCESSORY INFORMATION
5
A7139K - 11/01/11
Copyright © 1998, 2000, 2002,2005, 2207-2009, 2011, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part
without the express written permission of Sargent Manufacturing Company is prohibited.