SARGENT 1431 Series Aluminum Closer User Manual
Page 8
8
Copyright © 1998, 2000, 2002,2005, 2207-2009, 2011, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part
without the express written permission of Sargent Manufacturing Company is prohibited.
11/01/11
A7139K
Additional Power Adjustment
Adjusting foot for additional closing
power (for standard and top jamb
applications only)
1. For top jamb and corner bracket
applications: The door closer foot will
be attached to the door in a manner
similar to that shown for mounting the
closer body
2. For doors 2-1/4" thick: Mortise nut
shown for 1-3/4" thick doors will be
furnished along with appropriate length
through-bolts, door construction must
provide a bridge type reinforcement to
prevent the door rail form collapsing
with through-bolts are tightened.
INSTALL COVER AS FOLLOWS:
For standard an parallel arm application
• Screw short cover screw (#8-32 x 5/16") into top of case
approximately 2 turns
• Assemble plastic support and long cover screw (#8-32 x 1-1/4")
into bottom of case approximately 2 turns
• Hold support against case and slide cover into gap between
flange and screw head
• Position cover on closer and tighten screws
For top jamb application
• Assemble plastic support and long cover screw (#8-32 1-1/4")
into top of case approximately 2 turns
• Screw short cover screw (#8-32 x 5/16") into bottom of case
approximately 2 turns
• Slide cover into gap between flange and screw head. Position
cover on closer and tighten screws
Through Bolts