Parallel application – SARGENT 1431 Series Aluminum Closer User Manual
Page 4
4
Copyright © 1998, 2000, 2002,2005, 2207-2009, 2011, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part
without the express written permission of Sargent Manufacturing Company is prohibited.
11/01/11
A7139K
• Select closer mounting position based on the maximum door opening, as listed below
Note: For ADA applications, select the 180º position.
1
PARALLEL APPLICATION
• Using the enclosed self adhesive template, locate and mark hole locations
Note: 3/32" pilot holes are required when Self Tapping Screws are being used
If machine screws are being used, use a drill #16 (.177) and a #12-24 tap
2
• Install closer body onto the door with 5/8" power adjustment nut end towards hinge
• Install foot bracket & rod assembly onto the frames
3
Note: P9 or RP9 arm shown.
For P3, P3A, P4,P4A arms,
use data sheet enclosed
LEFT HAND DOOR SHOWN
SAME DIMENSIONS APPLY FOR RIGHT HAND DOOR
*SEE PAGE 8 FOR MORTISE NUTS