SARGENT 7000 Series Vertical Rod Lock - Manual (Page 15)

1/31/13
Copyright © 2013, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
A8147A • 800-810-WIRE (9473) • www.sargentlock.com 15
ELR 7000 Series Multi Point Lock
3. TIMER MODE Wiring
ElectroLynx Opening Installation
This is the simplest installation method, requiring the installer to plug the
ElectroLynx connectors from the device to the harness to the hinge and
then to the pigtail, which is connected to the access control system.
Requirements
• ELR 7000 series device
• ElectroLynx connector harness (not supplied with ELR- device)
• McKinney QC ElectroLynx hinge (type of hinge depends on the application)
• ElectroLynx door
2. TIMER MODE Installation Instructions (continued)
4. Connect the ElectroLynx harness to the hinge:
a. Plug the door harness’s 8-pin connector into the hinge’s ElectroLynx connector.
b. Secure the electric hinge to door.
Notes: Make sure no wires are pinched or damaged in the process.
Refer to detailed wiring instructions under
TIMER MODE wiring.
5. Apply 24V/12V according to ELR- input requirements:
Confirm that the LED is blinking and close the timer input circuit to retract the device. When the system retracts
electrically, confirm that it fully unlocks and that all bolts clear the strikes. Troubleshoot the device if issues are
observed using the steps outlined at the end of the TIMER MODE section.
6. Store excess wiring under cover and assemble with provided screws. Avoid pinching wires.
1 - Black (ELR 0VDC)
2 - Red (ELR +24VDC)
3 - White (TIMER A)
4 - Green (EG)
5 - Orange (TIMER B)*
Fig. 2 ElectroLynx TIMER MODE Wiring
ElectroLynx harness
with 8-and 4-pin connectors
(purchased separately)
8-pin F 8-pin M 8-pin M
7-pin M 4-pin M