Great Plains 2525P Operator Manual - Manual (Page 44)

2525P and 2520P
118-915M 4/23/2010
42
Refer to Figure 64
9. Engage the lower latch.
NOTE: To change from the Finger Pickup
meter to the Precision meter requires the
same steps.
Refer to Figure 65
The meter drive can be disengaged if a meter is
not being used.
1. Disengage the drive coupler by pulling out on
the pin, twisting it a quarter turn and resting it
in the shallow slot.
NOTE: A meter must always be assembled on
an opener whether it is being driven or not.
Damage will occur if no meter is in place.
Disengaging drive coupler is not required to
change meters.
22871
21968
21969
Figure 64
Figure 65