Great Plains 2525P Operator Manual - Manual (Page 82)

2525P and 2520P
118-915M 4/23/2010
80
Refer to Figure 105
4. Press Function key until the Calibration win-
dow appears as shown.
5. Press up arrow key to enter calibration mode.
Refer to Figure 106
6. This is the first window that appears in Cali-
bration mode. Press Function key to accept,
or Up key to change to metric settings.
Refer to Figure 107
7. Enter drill width here using Up/Down arrow
keys. Press Function key to advance to next
window.
Figure 105
Figure 106
Figure 107
22718
22717
22719