Great Plains NTA3007HD Operator Manual - Manual (Page 39)

Operating Instructions 35
04/04/2011 166-207M
Folding: Summary of Steps
Follow the detailed instructions in step 1 through step 22
until this is a familiar operation.
❑ Check marker, auger and ladder stowed (below).
❑ Check openers raised (page 33).
❑ Engage transport locks (page 35).
❑ Set tractor for fold (page 36).
❑ Fold wings (page 37).
❑ Tilt up wings (page 38).
❑ Engage transport hook (page 39).
Folding: Check Drill Configuration
1. Make sure
markers (page 61),
auger (page 53) and
ladder (page 44)
are secured in transport positions before unfolding.
2. Raise openers (page 33).
Refer to Figure 29
3.
Check that transport hooks are fully lowered (cylin-
der fully retracted). If not, Retract hook circuit as
needed.
4. Move to level ground.
Folding: Engage Transport Locks
Refer to Figure 30
At wing end
, mid wing , and side of mainframe ,
on each side (6 locations total), reconfigure locks from:
FIELD to ROAD
Null4:
Null4:
Figure 29
Transport Hook Ready for Fold
29399
Null4:
Figure 30
Transport Lock Locations
29423
1
2
3
1 2 3