Great Plains NTA3007HD Operator Manual - Manual (Page 52)

48 NTA907HD or NTA3007HD
166-207M 04/04/2011
Auger Operations (Option)
Auger Safety Information
Electrocution Hazard, Auger:
Keep clear of overhead power lines when positioning auger.
The auger can reach 5.3m (17.5ft) above ground level during
positioning operations. If the auger gets too close to, or con-
tacts a power line, nearly all metal parts of the tractor and
drill will have lethal voltage present, and anyone touching
them can complete the circuit to ground, resulting in serious
injury or death. With very high voltages, electrocution can
occur without direct contact.
Rotating Auger:
To prevent serious injury or death, read instructions and safety
information before operation. Keep hands, feet, hair and cloth-
ing away from rotating auger. Do not remove or modify any
guards. Keep children well clear of work area.
Overhead Auger Injury Hazard:
Allow only operators near auger during use. Keep both ends of
auger under control when tube contains material. Auger is
balanced and fully supported by springs only when empty. If
tube contains material, auger can move down suddenly when
released. If one end of auger contains more material, auger
can tip suddenly. Empty auger tube before storage. Use all
provided pins and latches.
High Pressure Fluid Hazard, Auger Hydraulic Motor:
Escaping fluid under pressure can have sufficient pressure to
penetrate the skin causing serious injury. Use a piece of paper
or cardboard, NOT BODY PARTS, to check for leaks. Wear
protective gloves and safety glasses or goggles when working
with hydraulic systems. If an accident occurs, seek immediate
medical assistance from a physician familiar with this type of
injury.
Set FAN/AUGER selector valve to AUGER after auger deploy-
ment. Set FAN/AUGER selector valve to FAN before auger
storage.
Pinch Point Hazard, Auger Support Linkage:
Allow only operators near auger during use. Keep hands away
from auger support linkage during deployment and storage. If
there is difficulty storing the auger, check that hydraulic hoses
are not being pinched.