Great Plains NTA3007HD Operator Manual - Manual (Page 60)

56 NTA907HD or NTA3007HD
166-207M 04/04/2011
Loading: with Auger
Refer to Figure 64
If the auger is not used for material load, skip to step 26.
14. Review auger safety information on page 48.
15. Deploy auger (page 48).
16. Configure hydraulics from fan to auger (page 51).
17. Before loading material in auger inlet hopper, oper-
ate auger to establish correspondence between con-
trol handle direction and auger screw direction.
18. Swing the auger so the spout is centered over the
hopper opening. Position your grain container for
unloading into the auger hopper.
19. Energize tractor hydraulics for auger. You may need
to tie the control lever in place or adjust the detent
pressure on your tractor.
Rotating auger. To prevent serious injury or death:
▲ Read instructions and safety information before operation.
▲ Keep hands, feet, hair and clothing away from rotating
auger.
▲ Do not remove or modify any guards.
▲ Keep children well clear of work area.
20. Slowly turn on material flow and fill hopper.
21. When hopper is full, turn off the auger by moving the
auger direction control to the center position.
22. Shut off tractor hydraulics, or set auger/fan circuit to
neutral or float.
23. When hopper is full, or material supply consumed,
reverse direction of auger to return any residual
materials to inlet for recovery.
24. Return auger to storage/transport configuration
(page 53).
25. When circuit is off, set diverter to up (pass-through to
markers or fan). See “Auger Hydraulic Controls”
on page 51
Loading: Close-Out
26. Remove any foreign matter from the strainer basket.
27. Wipe any grain or foreign matter from lid-seal area
on top of hopper bin. Close lids and latch securely.
28. Return ladder to storage/transport position
(page 44).
Null4:
Null4:
Null4:
Null4:
Null4:
Note: Hopper fill level indications are molded into the side
of the hopper.
Figure 64
Auger Set for Rear Hopper Load
29415