Bio-Rad Gel Doc™ EZ System - Manual (Page 22)

Criterion Stain Free TM System | Criterion Stain Free System Overview
8
6. “Install the software automatically” is selected by default.
Click on “Next”.
The screen below appears:
7. Click on “Continue Anyway”. Windows will install the driver.
8. Click on the “Finish” button when it appears. A message appears briefly
on the lower right corner of the screen indicating “Your new hardware is
ready to use”.
NOTE: Windows XP may prompt you to go through the driver
installation a second time. If this happens, repeat steps 5
through 8, until you receive the “Your new hardware is ready to
use” message.