Bio-Rad Gel Doc™ EZ System - Manual (Page 74)

Criterion Stain Free System | Editing Results
60
S INGLE L ANE
Add - You can add a single lane to your gel image. First click the Add button,
then click within the lane frame where you want the new lane. The lanes will
renumber.
Delete - You can delete a single lane. First click the Delete button, then click
either on the lane or its lane number. The lanes renumber.
Move - You can move a single lane to a new position on your gel image. First
click the Move button, then click on the lane you want to move. Drag it to a
new location. The lanes will be renumbered, according to their new position.
Bend - You can bend a single lane to better fit your gel image. First click the
Bend button, then click and drag one of the square anchors to fit your image.
You can add additional anchor points within the lane, by left-clicking your
mouse. Drag these anchor points to adjust the lane to fit the gel image.
Remove anchor points by right-clicking them with your mouse.
3. Band Tools
B AND F INDER
This tool allows you to detect bands or reset band detection settings. See
“Step 3. Detect Lanes And Bands” on page 37 for a discussion of this tool.
B AND T OOLS
Add - Use this option to add faint detected bands. First click the Add button,
then add a new band by clicking anywhere inside of a lane.
NOTE: You can darken your entire image to view detected bands
more easily, by using the Gamma slider in the Image Transform
dialog. For complete instructions, see “Image Transform” on
page 46.