Bio-Rad BioLogic QuadTec™ Detector and Components - Manual (Page 14)

2.2 ELECTRICAL CONNECTIONS TO THE DUOFLOW SYSTEM
The QuadTec communicates with the BioLogic DuoFlow system via the ICM module. To connect the
QuadTec to the DuoFlow system:
1. Use System Cable 25 to connect from the RS232 connector on the back of the QuadTec to the
COMM connector on the ICM module.
2. Use System Cable 26, the ICM power cord, to connect to the back of the workstation.
3. Use System Cable 17 to connect between an instrument bus connector on the ICM and an available
instrument bus connector on the workstation.
4. If you are using a Bio-Rad device with an instrument bus connector, such as the Model 2128 fraction
collector, use another system cable 17 to connect between the instrument bus connectors on the
Model 2128 and the ICM.
Figure 2-3. Connecting to the DuoFlow System
USE WITH THE BIOLOGIC DUO-FLOW SYSTEM SYSTEM INSTALLATION AND SETUP
2-3
COLOR MONITOR
WORKSTATION
MODEL 2128
FRACTION COLLECTOR
SYSTEM
CABLE 17
CONDUCTIVITY
MONITOR
SYSTEM CABLE 17
SYSTEM CABLE 25
SYSTEM CABLE 17
SYSTEM CABLE 26,
ICM POWER CORD
CONTROLLER
AVR7-3
INJECT
VALVE
MODEL 1327
CHART RECORDER
SYSTEM
CABLE 2 SYSTEM
CABLE 4
MIXER
QUADTEC
DETECTOR ICM MODULE
KEYBOARD
MOUSE