Bio-Rad BioLogic QuadTec™ Detector and Components - Manual (Page 36)

4.4.3 Time Programming of Absorption Wavelengths
Use this instruction for programming the absorption wavelengths as a function of time.
1. Access the Operation/Main menu screen.
2. Move cursor to the field “Edit Prog” and select a number (1 to 20) for the new program.
3. Press any arrow key to confirm and enter Edit mode for the new program.
4. The cursor is automatically moved to Time 000.0, which is the fixed start time.
5. Press the Right arrow key to go to field 1. Enter the desired wavelength (e.g. 220 nm).
6. Move cursor to field 2 and enter your second desired wavelength (e.g. 254 nm).
7. Press the Down arrow key to create the next step of the program. The blinking cursor will be on the
first asterisk of the time field.
8. Press 1 and 0 and then the Right arrow key to define the time step as 10.0 min. Enter field 1 and put
in 240 nm and complete entering by pressing the Down arrow key. The value for 2 (254 nm) is kept
constant as long as no changes are made.
9. Repeat the last two steps, define time step 20.0 min and enter 280 nm.
Figure 4-11. Four Steps for Creating a Program
USE AS A STAND-ALONE SYSTEM SYSTEM INSTALLATION AND SETUP
4-9
Link
View
Setup
Load
Prog
Hold 0
Run 1 Time
(min) 1
(nm) 2
(nm)
Edit Prog
Clear 0 Events:
off 0 2
on /
Signal 1
[ au ]
Signal 2
[ au ]
GLP
Link
View
Setup
Load
Prog
Hold 0
Run 1 Time
(min) 1
(nm) 2
(nm)
Edit Prog
Clear 0 Events:
off 0 2
on /
Signal 1
[ au ]
Signal 2
[ au ]
GLP
Link
View
Setup
Load
Prog
Hold 0
Run 1 Time
(min) 1
(nm) 2
(nm)
Edit Prog
Clear 0 Events:
off 0 2
on /
Signal 1
[ au ]
Signal 2
[ au ]
GLP
Link
View
Setup
Load
Prog
Hold 0
Run 1 Time
(min) 1
(nm) 2
(nm)
Edit Prog
Clear 0 Events:
off 0 2
on /
Signal 1
[ au ]
Signal 2
[ au ]
GLP