Bio-Rad BioLogic QuadTec™ Detector and Components - Manual (Page 33)

4.2.3 VIEW Menu
The View menu gives an overview of existing programs and program links. The following figure shows an
example where programs 01, 02, 03, 04, and 11 and link 21 have been defined.
Figure 4-7. Overview of the View Menu
4.3 STAND-ALONE CONTROL OF THE QUADTEC UV/VIS DETECTOR
When using the QuadTec detector, note the following:
• Direct control of the QuadTec UV/Vis detector is performed via the Main Menu/Operation screen,
e.g. selection of wavelength(s).
• Programs can be used for determining and changing wavelengths or setting signal events during
runs. The QuadTec UV/Vis detector features storage and selection between up to 20 different
programs with a maximum number of 100 program lines for each program. Nine different links can
be stored for calling programs within programs.
• A useful feature of the QuadTec UV/Vis detector is its ability to scan UV-spectra with a speed of
approximately. 100 nm/s on flow. Scans are handled in the SCAN menu, which is accessed simply
by pressing the SCAN button.
After power on, the instrument starts automatically with the last used program. If no programs had been
loaded, the standard program is defined to be No. 01.
Figure 4-8. Standard Operation Screen with Cutoff Filter Activated
USE AS A STAND-ALONE SYSTEM SYSTEM INSTALLATION AND SETUP
4-6
Link
View
Link
View
Setup
Load
Prog
Hold 0
Run 1 Time
(min) 1
(nm) 2
(nm)
Edit Prog
Clear 0 Events:
off 0 2
on /
Signal 1
[ au ]
Signal 2
[ au ]
GLP