Dell C7765DN MFP Color Laser Printer - Manual (Page 508)

19 Scanner Environment Settings
508
Configuration of Store to WSD
This section describes how to configure the machine to use the Store to WSD service.
Note • WSD stands for Web Services on Devices.
The following shows the reference section for each procedure.
Step 1 Preparations ..................................................................................................................508
Step 2 Enabling Port................................................................................................................508
Step 3 Confirmation on the Computer ..................................................................................509
Step 1 Preparations
The following environment is required to use the Store to WSD feature on the machine.
• The following operation system must be installed on a destination computer.
- Microsoft Windows 8
- Microsoft Windows 7
- Microsoft Windows Vista Service Pack 2
Note • WSD stands for Web Services on Devices.
Step 2 Enabling Port
To use the Store to WSD service, enable the WSD scan port. The following describes the
configuration procedures on the machine.
Note • WSD stands for Web Services on Devices.
• You can configure the settings using Dell Printer Configuration Web Tool. For information on how to
use Dell Printer Configuration Web Tool, refer to "Configuring Machine Settings Using Dell Printer
Configuration Web Tool" (P.465).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter]. When a passcode is required, select [Next]
and enter the system administrator's passcode, and select [Enter].
Note • The default user ID is "admin".
• The default passcode is "1111".
3) Select [Tools] on the [Home] screen.
2
Enable the port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [WSD], and then select [Change Settings].
4) Select [WSD Scan - Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.