Dell PowerVault DP100 - Manual (Page 34)

The system board can accommodate a single processor, five expansion cards, and four memory modules. The hard-drive cage provides space for up to four
SAS or SATA hard drives. Two 5.25-inch external drive bays in the front of the system can accommodate optical or tape drives; a single 3.25 drive can
accommodate an optional diskette drive. A controller expansion card is required to use SAS hard drives. Power is supplied to the system board and internal
peripherals through a single, nonredundant power supply.
Opening the System
Removing the Bezel
You must remove the bezel to remove the system cover.
1. Using the system key, unlock the bezel. See Figure 3 -2 .
2. Slide the bezel latch toward the right side of the system.
3. Swing the top of the bezel away from the system, disengage the hooks at the bottom of the bezel, and lift the bezel away from the system.
Figure 3-2. Removing the Bezel
Removing the Cover
1 front fan 2 drive cage 3 expansion cards (optional)
4 cooling shroud 5 power supply 6 5.25-inch drive bays (2)
7 chassis-intrusion switch
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer and protecting against electrostatic discharge.
1 bezel latch 2 bezel 3 keylock