Dell PowerVault DP100 - Manual (Page 49)

6. Pull the fan assembly forward and lift the assembly out of the system. See Figure 3 -16 .
Figure 3-16. Removing the Back System Fan
Installing the Back System Fan
1. Align the tabs on the fan bracket with the mounting holes in the back panel and slide the fan assembly toward the power supply about 0.63 cm (0.25
inch) until the fan bracket release tab snaps into place. See
Figure 3 -16 .
2. Connect the fan cable to the BACK_FAN connector on the system board.
To identify system board connectors, see System Board Connectors .
3. Install the cooling shroud. See Installing the Cooling Shroud ."
4. Close the system. See Closing the System .
5. Stand the system upright.
6. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Power Supply
Removing the Power Supply
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See Opening the System .
3. Disconnect the DC power cables from the following components:
1 release tab 2 fan cable connector 3 BACK_FAN connector
4 back system fan
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer, and protecting against electrostatic discharge.
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer, and protecting against electrostatic discharge.