Dell PowerVault DP100 - Manual (Page 69)

Console Redirection Screen
Table 2 -5 lists the options and descriptions for the information fields that appear on the Console Redirection screen.
Table 2-5. Console Redirection Screen Options
System Security Screen
Table 2 -6 lists the options and descriptions for the information fields that appear on the System Security screen.
Table 2-6. System Security Screen Options
Exit Screen
After you press <Esc> to exit the System Setup program, the Exit screen displays the following options:
l Save Changes and Exit
l Discard Changes and Exit
Option Description
Console Redirection
(Off default) Sets the console redirection feature to Serial Port or Off.
Failsafe Baud Rate
(11520 default) Displays if the failsafe baud rate is used for console redirection.
Remote Terminal Type
(VT 100/VT 220 default) Select either VT 100/VT 220 or ANSI.
Redirection After Boot
(Enabled default) Enables or disables console redirection after your system restarts.
Option Description
System Password Displays the current status of your system's password security feature and allows you to assign and verify a new system password.
NOTE: See Using the System Password for instructions on assigning a system password and using or changing an existing system
password.
Setup Password Restricts access to the System Setup program in the same way that you restrict access to your system using the system password
feature.
NOTE: See Using the Setup Password for instructions on assigning a setup password and using or changing an existing setup password.
Password Status Setting the Setup Password option to Enabled prevents the system password from being changed or disabled at system start-up.
To lock the system password, assign a setup password in the Setup Password option and then change the Password Status option to
Locked. In this state, you cannot change the system password using the System Password option and cannot be disabled at system
start-up by pressing <Ctrl><Enter>.
To unlock the system password, enter the setup password in the Setup Password field and then change the Password Status option to
Unlocked. In this state, you can disable the system password at system start-up by pressing <Ctrl><Enter> and then change the
password using the System Password option.
Front-Bezel
Chassis Intrusion Enables or disables the chassis-intrusion detection feature.
Power Button Turns system's power off and on.
l If you turn off the system using the power button and the system is running an ACPI-compliant operating system, the system can
perform an orderly shutdown before power is turned off.
l If the system is not running an ACPI-compliant operating system, power is turned off immediately after the power button is
pressed.
The button is enabled in the System Setup program. When disabled, the button can only turn on system power.
NOTE: You can still turn on the system by using the power button, even if the Power Button option is set to Disabled.
AC Power
Recovery
(Last default) Determines how the system reacts when power is restored to the system. If system is set to Last, the system returns to the last power
state. On turns on the system after power is restored. When set to Off, the system remains off after power is restored.