Dell PowerVault DP100 - Manual (Page 62)

14. Replace the cooling shroud. See Installing the Cooling Shroud .
15. Connect the two power cables to connectors PWR_CONN and 12V on the system board.
16. Carefully check for any remaining cables or components that are not installed or are improperly seated in their connectors on the system board.
17. Close the system. See Closing the System .
18. Stand the system upright.
19. Reconnect the cables to the I/O connectors on the system back panel.
20. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Back to Contents Page