Dell PowerVault DP100 - Manual (Page 52)

10. Install any device drivers required for the card as described in the documentation for the card.
Figure 3-19. Removing and Installing an Expansion Card
Removing an Expansion Card
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See Opening the System .
3. Disconnect any cables attached to the card.
4. Remove the expansion card (see Figure 3 -19 ):
a. Remove the screw that secures the expansion-card bracket to the back panel.
b. Grasp the expansion card by its top corners, and carefully remove it from the expansion-card connector.
5. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the expansion-card latch.
6. Close the system. See Closing the System .
7. Stand the system upright.
8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Replacing the SAS Controller Card Battery
1. Disconnect the battery cable from the SAS controller card.
Figure 3-20. Replacing the SAS Controller Card Battery
1 screw 2 expansion card 3 card-edge connector
4 expansion-card connector
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer, and protecting against electrostatic discharge.
NOTICE: You must install a filler bracket over an empty expansion slot to maintain Federal Communications Commission (FCC) certification of the
system. The brackets also help keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.