Dell PowerVault DL2000 - Manual (Page 22)

Table 2-2 Command line switches for the Storage Provisioning Option
(continued)
Description Switch Operation Function
Returns a 1 if the disk
cannot be configured
because it is in a bad state.
Returns a 0 if the disk is
available for configuration
so that Backup Exec can
use it. -ucf:unconfigurable
Outputs the properties for
a specified storage array.
Returns a 1 if the
command succeeds or a -1
if the command fails. -o532 View storage array
properties
Lists all the storage arrays. -sa:
Required.
Specifies the IDs or the
names of the storage
array. You should separate
the multiple IDs or
multiple names with a
comma.
-si:storage
array IDs
or
-sn:storage
array names
Lists all the virtual disks. -vd:
Specifies the IDs or the
names of the virtual disk
on the storage array. You
should separate the
multiple IDs or multiple
names with a comma. -vi:virtual
disk IDs
or
-vn:virtual
disk names
Configures a virtual disk
on a storage array to use
with Backup Exec. Returns
a 1 if the command
succeeds or a -1 if the
command fails. -o534 Configure a virtual
disk on a storage
array
Installing and configuring Backup Exec by using the Storage Provisioning Option
About using the Backup Exec Command Line Applet with the Storage Provisioning Option 22