Dell PowerVault DL2000 - Manual (Page 30)

Name Displays the name Backup Exec assigns
to the virtual disk. The name is VIRTDISK
x , where x is a number that increments
each time that you add a virtual disk. You
can edit this field to rename the device.
Names cannot exceed 128 characters.
You can choose a name if you use the
Dell™ OpenManage™ Server
Administrator to configure the virtual
disk. To change the name of the virtual
disk, use the Dell™ OpenManage™ Server
Administrator.
The current status of the virtual disk is
checked.
Statuses for a virtual disk are as follows:
■ Pause.
The virtual disk is temporarily
stopped.
■ Enable.
The virtual disk is available for use
with Backup Exec. If the virtual disk
is disabled, it is available for use with
other applications. Backup Exec does
not monitor the low disk space
thresholds for a disabled virtual disk.
■ Online.
The virtual disk is available for use.
■ Offline.
Backup Exec cannot access the virtual
disk. You can check Offline to try to
bring the storage array online.
Status
The amount of raw capacity of all of the
physical disks in the storage array that
were used. Backup Exec calculates used
capacity by subtracting available capacity
from total capacity. Used capacity
The name that the Dell™ OpenManage™
Server Administrator assigns to the
virtual disk. Hardware name
Viewing general properties, components, and virtual disks in Backup Exec
About viewing storage array components in Backup Exec 30