Dell PowerVault DL2000 - Manual (Page 27)

3 In the task pane, under General Tasks, click Properties.,and then click the
General tab.
4 On the General tab, view the following information:
Displays the name that Backup Exec assigns
to the storage array. The name is ARRAYx,
where x is a number that is incremented each
time that you add a storage array. You can
edit this field to rename the device. Names
cannot exceed 128 characters.
The name differs if you use the Dell™
OpenManage™ Server Administrator to
configure the storage array. To change the
name of the storage array, you must use the
Dell™ OpenManage™ Server Administrator.
Name
Lists the current status of the storage array.
Statuses are as follows:
■ Pause.
The storage array is temporarily stopped.
You can pause a storage array to perform
maintenance activities. Active jobs are
not affected if they start before the
storage array is paused.
■ Enable.
The storage array is available for use with
Backup Exec. If the storage array is not
enabled, it is available for use with other
applications.
■ Online.
The storage array is available for use.
■ Offline.
Backup Exec cannot access the storage
array. You can click this check Offline to
try to bring the storage array online.
■ Failed.
Backup Exec cannot access the storage
array.
See the Backup Exec for Windows Servers
Administrator's Guide.
Status
27 Viewing general properties, components, and virtual disks in Backup Exec
About viewing storage array components in Backup Exec