Dell PowerEdge R300 User Manual
Page 108
108
Installing System Components
2 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
3 Open the system. See "Opening the System" on page 71.
4 If applicable, disconnect the SAS cable connector on the expansion card.
5 Remove the system board shroud. See "Removing the System Board
6 Position your thumb firmly over the socket-release lever and release the
lever from the locked position. Rotate the lever 90 degrees upward until
the processor is released from the socket. See Figure 3-20.
7 Gently lift the heat sink off of the processor and set the heat sink aside.
NOTICE:
The processor is held in its socket under strong pressure. Be aware that
the release lever can spring up suddenly if not firmly grasped.
book.book Page 108 Sunday, June 21, 2009 5:16 PM