Dell PowerEdge R300 - Manual (Page 24)

24
About Your System
E1211 ROMB Batt RAID battery is either
missing, bad, or unable to
recharge due to thermal
issues. Reseat the RAID battery
connector. See
"Troubleshooting a SAS or
SAS RAID Controller" on
page 147, and
"Troubleshooting System
Cooling Problems" on
page 136.
E1214 ## PwrGd Specified voltage regulator
has failed. See "Getting Help" on
page 167.
E1215 ## PwrGd Specified voltage regulator
has failed. See "Getting Help" on
page 167.
E1226 PCI Rsr 1.5V
PwrGd
1.5V Riser Card Power Good
failure. See "Getting Help" on
page 167.
E1229 CPU # VCORE Processor # VCORE voltage
regulator has failed. See "Getting Help" on
page 167.
E122A CPU VTT PwrGd Processor # VTT voltage has
exceeded the allowable
voltage range See "Getting Help" on
page 167.
E1310 RPM Fan ## RPM of specified cooling
fan is out of acceptable
operating range. See "Troubleshooting
System Cooling
Problems" on page 136.
E1311 FAN MOD ##
RPM
RPM of specified cooling
fan module is out of
acceptable operating range. See "Troubleshooting
System Cooling
Problems" on page 136.
E1313 Fan
Redundancy
The system is no longer fan-
redundant. Another fan
failure will put the system at
risk of over-heating. Check control panel LCD
for additional scrolling
messages. See
"Troubleshooting System
Cooling Problems" on
page 136.
Table 1-6. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 24 Sunday, June 21, 2009 5:16 PM