Dell PowerEdge R300 - Manual (Page 39)

About Your System
39
No boot sector on
hard drive
Incorrect configuration
settings in System Setup
program, or no operating
system on hard drive. Check the hard-drive
configuration settings in the
System Setup program. See
"Entering the System Setup
Program" on page 47. If
necessary, install the
operating system on your
hard drive. See your
operating system
documentation.
No timer tick
interrupt
Faulty system board. See "Getting Help" on
page 167.
Not a boot diskette No operating system on
diskette. See "Troubleshooting a
Diskette Drive" on page 140.
PCI BIOS failed to
install
PCIe device BIOS
(Option ROM) checksum
failure detected during
shadowing.
Cables to expansion
card(s) loose; faulty or
improperly installed
expansion card(s).
Reseat the expansion card(s).
Ensure that all appropriate
cables are securely connected
to the expansion card(s). If
the problem persists, see
"Troubleshooting Expansion
Cards" on page 149.
PCIe Fatal Error
caused a system
reset: Slot X
Embedded
Bus#XX/Dev#XX/Func
X
Please check the
system event log
for details
PCI Express fatal errors
occurred during the
previous boot. Reseat the PCIe card in the
specified slot number. See
"Installing an Expansion
Card" on page 96. If the
problem persists, see
"Getting Help" on page 167.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
book.book Page 39 Sunday, June 21, 2009 5:16 PM