Dell PowerEdge R300 - Manual (Page 127)

Troubleshooting Your System
127
Action
1 Check the system and power connections to the monitor.
2 Determine whether the system has an expansion card with a video output
connector.
In this system configuration, the monitor cable should normally be
connected to the connector on the expansion card,
not to the system’s
integrated video connector.
To verify that the monitor is connected to the correct video connector,
turn off the system and wait for 1 minute, then connect the monitor to the
other video connector and turn the system on again.
3 Run the appropriate online diagnostic test. See "Using Dell PowerEdge
Diagnostics" on page 153.
If the tests run successfully, the problem is not related to video hardware.
If the tests fail, see "Getting Help" on page 167.
Troubleshooting the Keyboard
Problem
• System message indicates a problem with the keyboard.
• Keyboard is not functioning properly.
Action
1 Enter the System Setup program and ensure that the USB ports are
enabled. See "Entering the System Setup Program" on page 47.
2 Examine the keyboard and its cable for signs of damage.
3 Swap the faulty keyboard with a working keyboard.
If the problem is resolved, replace the faulty keyboard. See "Getting Help"
on page 167.
4 Run the appropriate online diagnostic test. See "Using Dell PowerEdge
Diagnostics" on page 153.
If the problem is not resolved, see "Getting Help" on page 167.
book.book Page 127 Sunday, June 21, 2009 5:16 PM