Dell PowerVault DR2000v - Manual (Page 116)

Access Controller (iDRAC).
--ip Static IP address to use.
--netmask Netmask for the assigned static IP address.
--gateway Gateway for routing.
--device Network device for iDRAC. By default, if you do not
specify a device, the iDRAC port will be used.
For example, to enable the remote access, you can run a similar command like the one below:
maintenance --remote_access --enable --static_ip --ip 10.250.241.167 --netmask
255.255.252.0 --gateway 10.250.240.1
Result
Successfully enabled remote access
maintenance --remote access [--disable]
Description
The command disables the iDRAC access (default: DHCP).
Syntax
maintenance --remote access --disable
Result
Successfully disabled remote access
maintenance --vdisk --check_consistency --type <boot|internal|external> [--service_tag
<service tag>]
Description
Manages virtual disk drives.
•
check_consistency — Starts vdisk consistency check.
• type — Type of the vdisk (boot/internal/external).
• service_tag — Service tag of the external storage.
Syntax
maintenance --vdisk --check_consistency --type internal
Result
Vdisk check: Successful.
maintenance --help
Description
Displays the list of maintenance-related options that can be used as a reference when using the DR Series system CLI.
Syntax
maintenance --help
Result
Usage:
maintenance --filesystem [--scan_status]
[--scan_report [verbose]]
[--repair_status [verbose]]
116