Dell PowerVault DR2000v - Manual (Page 133)

Replication Enabled : No
Replication Compression Enabled : Yes
Replication Encryption : AES 128-bit
replication --limit --speed <<num><kbps | mbps | gbps> | default> --target <ip address |
hostname>
Description
Limits the bandwidth used during replication by defining a bandwidth limit using any of the following settings:
• Kilobytes/second (kbps)
• Megabytes/second (mbps)
• Gigabytes/second (gbps)
• Unlimited bandwidth (this is the default setting); minimum allowed bandwidth setting is 192 kbps
Configures replication limits for a DR Series system.
Syntax
replication --limit --speed 10gbps --target acme-60
Result
Successfully updated replication limit for acme-60 to 10 Gbps.
Changing traffic control policies ... done.
replication --resync --name <name> --role <source | target>
Description
Resynchronizes the replication process between a source and target container in a replication relationship on a DR
Series system. This command should only be used in an emergency situation with the help of Dell Support. Do not
mistake this command as an ability to start a replication sync outside of the schedule window. If your intention is to start
a replication outside of the window, you can either delete the schedule, or add a temporary replication window to the
current schedule and delete it when the systems are in sync.
Syntax
replication --resync --name dataStorage3 --role source
Result
Successfully initiated replication resync on container dataStorage3.
replication --troubleshoot --peer <ip address | hostname>
Description
Troubleshoots the replication connections between a source and target container on a DR Series system.
Syntax
replication --troubleshoot --peer 10.25.19.5
Result
The following examples shows both successful and unsuccessful replication connection attempts:
Testing connection to port 9904... Connected!
Testing connection to port 9911... Connected!
Testing connection to port 9915... Connected!
133