Dell PowerVault DR2000v - Manual (Page 61)

To verify the current state of an RDA client, you can check the two sources:
• DR Series system CLI, using the rda --show --clients command
• DR Series system GUI, displaying the Clients page
These sources display information about the connected and configured clients. When a system is connected multiple
times, these sources show the number of connections to that client and the mode. You can also change the mode from
dedupe to the other supported modes. When this is done the displayed mode changes, but any active connections
remains. There are essentially two possible modes: Dedupe and Passthrough. To verify the current mode of an RDA
client, you can check the two sources of client statistics:
• DR Series system CLI, using the stats --container --name command
• DR Series system GUI, displaying the Container Statistics page
In the Container Statistics page, click the Client Statistics tab (under Connection Type: RDS) to display the Client
Statistics table. If the Network Savings level in this table displays some savings and the displayed Bytes Ingested value
is different from the displayed Bytes Transferred, it indicates that the RDA clients are working in the Dedupe mode. If
not, it indicates that the RDA containers are working in the Passthrough mode.
rda --update --opdup_encryption <none | aes128 | aes256>
Description
Sets the type of encryption that will be used by RDA initiated opdup replication.
Syntax
rda --update --opdup_encryption aes128
Result
RDS OPDUP encryption updated to aes128
rda --setpassword
Description
The command updates the Rapid Data Access (RDA) user password.
Syntax
rda --setpassword
For example, to set the rda password, run the command: rda ––setpassword
NOTE: The password has to be between 8 and 12 characters and cannot contain quotes.
Result
Enter new password for backup_user:Dell1234
Re-type new password:Dell1234
Rapid Data Access (RDA) password updated successfully.
rda --delete_client --name <RDA Client Hostname>
Description
The command deletes the Rapid Data Access (RDA) client and any edits that were made to its default values. The next
time a connection is established between the client and the DR Series system, the default RDA connection settings will
be used. Deleting an RDA client using this CLI command does not affect data already written to the DR Series system.
61