Dell PowerVault DR2000v - Manual (Page 46)

--bondif Bond interface(s) to delete.
--nwif Eth interface(s) to dele
For example, to enable eth2, run the command: network --enable --nwif eth2
Result
Interface device operation successful. Please restart networking for the
changes to take effect.
network --disable
Description
The command does not start the specific ethernet device(s) on restart.
Syntax
network --disable [--bondif <bond0,bond1,...,bondN>]
[--nwif <eth0,eth1,...,ethN>]
--bondif Bond interface(s) to delete.
--nwif Eth interface(s) to dele
NOTE: You cannot disable eth interfaces which are part of a bond.
For example, to disable eth2, run the command: network --disable --nwif eth2
Result
Interface device operation successful. Please restart networking for the
changes to take effect.
network --troubleshoot [--links] [--gateway] [--ntp] [--dns] [--active_domain] [--nis] [--
clients] [--port_mapper] [--network_config] [--show_active <nfs | cifs | ost | rds>] [--
interface <bondN | ethN>]
Isolates a variety of networking issues that you might encounter while running a DR Series system. When you can
isolate a problem or issue to a specific cause, you can better understand and resolve it. The DR Series system CLI
network --troubleshoot command and its options allow you to perform basic troubleshooting checks on the state of a DR
Series system.
Description
NOTE: When entering the network --troubleshoot command string, the DR Series system checks and displays the
current state for all of the --troubleshoot options. To limit the type of network troubleshooting check you want to
display, define the command string to a specified check (or checks). For example, using network --troubleshoot --
gateway, displays the status of the gateway for a DR Series system (for details, see
network --troubleshoot [--
gateway] ).
Syntax
network --troubleshoot
Result
*** Checking link status for each interface
bond0 : Link detected: yes
eth0 : Link detected: yes
eth1 : Link detected: yes
46