Canon E 700 - Manual (Page 14)

Installing the lithium battery
Even when the camera is turned off, it can
remember the date and time, an age and a title. Its
memory is powered by a CR2025 lithium battery
with a lifespan of about a year.
“DATE” flashes in the viewfinder if you have not
installed the lithium battery, or if it is almost
exhausted.
1. If you are replacing an old battery,
attach a power source to the camera.
• If the memory does not have another power
source while you are changing the lithium
battery, it will be erased and you will have to
reset the date, time, age and title.
2. Rotate the FlexIGrip downwards so the
lithium battery compartment is visible.
• Hold down the GRIP UNLOCK button while
you rotate the FlexiGrip.
3. Pull out the lithium battery holder.
• Hold the camera with the FlexiGrip
underneath, or the old battery will fall out
when you remove the holder.
4. Place the new battery in the holder with
the + side facing upwards.
• Do not pick up the battery using tweezers or
other metal tools — this may cause a short
circuit.
• Wipe the battery with a clean, dry cloth to
ensure proper contact.
WARNING
• The battery used in this device may present a
fire or chemical burn hazard if mistreated. Do not
recharge, disassemble, heat above 100°C or
incinerate.
• Replace the battery with a Sanyo CR2025,
Panasonic CR2025 or Duraceli DL2025B. Use of
another battery may present a risk of fire or
explosion.
• The used battery should be handed back to the
supplier for safe disposal.
• Keep the battery out of reach of children — if it is
swallowed, contact a physician immediately.
a
0)
0)
o'
O
n
D)
5. Click the battery holder back into place.