Canon E 700 - Manual (Page 27)

Titles
FiVS Pt>Y ngiV/B
You can write your own titles and store them in the
camera’s memory in order to add them to your
recordings.
The title stored in the memory is displayed in the
viewfinder when you press the C.TITLE button. If
you start recording now, it will be superimposed on
the scene.
Press the button again to cancel the display. If it
does not appear in the viewfinder, it will not be
recorded.
Press the + and - buttons to scan the
list of title characters.
• Press once to scan one at a time; press and
hold to scan quickly.
• You can choose from the following characters:
r^ABCDEFGHIJKLMNOPQRSTUVWXYZ<----------- ,
,987654321 O^EgN/EA0UOA<-l
• If you choose the flashing dot nothing will
be recorded at this position.
• You can erase all the characters at and to the
right of the cursor by pressing the C.RESET
button.
Writing a title
(0
c
o
o
c
■o
«
o
These lines appear in the
viewfinder while you are writing a
title.
a Enter your title in the camera’s memory before you
"o start recording. The title can be one or two lines of
up to 16 characters each.
6 .
When the character you want Is
displayed, press the SHIFT button again
to move the cursor to the point where
you want to write the next character.
Repeat steps 4 and 5 until your title Is
complete, then press the C.TITLE
button to enter the title in the memory.
1. Put the camera in record pause mode.
2. Press and hoid the C.TiTLE button untii
the title lines appear in the viewfinder.
• If you have already entered a title in the
memory, it will be displayed in the viewfinder.
• The first dot (or character) flashes to show
where the cursor (the insertion point) is
located.
3. Press the SHIFT button to move the
cursor to the point where you want to
start the title.
• Press once to move the cursor one space
right; press and hoid to move it quickly.