Canon E 700 - Manual (Page 15)

Battery Pack Notes
&
о
о
‘й
(S
m
Charge the battery pack before you use it...
• You should charge a brand new battery pack
twice before using it for the first time — a single
charge may not be enough. Charge it completely
(until the adapter’s charge indicator glows
steadily), then disconnect it and charge it again.
This is the only time you should ever “double
charge” the battery pack.
• The battery pack will naturally discharge itself
over time. You should charge it the same day you
plan to use it, or the day before.
• The battery pack becomes warm during use (and
during charging). Wait for it to cool before
charging or using it again.
• See the adapter instructions for details.
...save power while you are recording...
• You will get more recording time from your
battery pack if you turn the camera off between
shots, instead of leaving it in record pause mode.
• Recording time will be shorter than usual at low
temperatures. You can use the battery pack
between 0° and 40° C (32°-104° F), but it works
best between 10° and 30° C (50°-86° F).
...and don’t recharge it until it is
exhausted.
• The camera flashes a “ВАТТ’ warning when the
charge has almost run out. After a few more
minutes’ use, the camera turns off automatically.
You can now either recharge or store the battery
pack.
Disconnect the battery pack when you are
not using it.
• Even when it is turned off, the camera will
continue to slowly drain power from the battery
pack. This means the battery pack will be
discharged beyond the normal level if you leave it
attached for a long time.
DANGER!
Always attach the terminal cover.
• Do not allow any metal objects to touch the
terminals. The battery pack contains a great deal
of energy and short-circuiting it may cause a fire.
Attach the terminal cover whenever you are not
using the battery pack.
Treat the battery pack with care.
• Keep it away from fire (or it might explode).
• Do not try to disassemble or modify it.
• Do not drop or knock it.
• Do not get it wet.
Keep the terminals clean.
• The camera, adapter or battery pack will not work
properly if the terminals are dirty. Check them
before use, and wipe them with a dry cloth or
tissue if necessary.
Remember, it may start to give you less
recording time...
• If you recharge it without first completely
discharging it.
• If you leave it attached to the camera (or video
light) for more than a week.
• If you don’t use it for three months or more.
...but you should be able to “refresh” it.
• Discharge the battery pack by operating the
camera until it turns ofif automatically (see p. 10).
Recharge and repeat a few times.
• The MC-100 Multi-battery Charger (p. 34)
refreshes battery packs automatically.
• If this does not improve the battery pack’s
performance, it has reached the end of its life and
must be replaced.