Cautions and maintenance, Avoid high temperatures and high, Avoid sudden changes in temperature – Canon E 700 User Manual

Page 39: Do not point the lens at strong light, Sources, Avoid magnetic or electric fields, Do not expose the camera to water, Always replace the lens cap, Handle the camera gently, Do not disassemble the camera

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Cautions and Maintenance

(0

c

o

I?

V

■o

<

Cautions

Maintenance

Avoid high temperatures and high
humidity.
• Do not leave the camera inside a car in hot

weather, for example.

• Be careful of heat radiating from video lighting

equipment.

• Do not take the camera into a humid room.

Avoid sudden changes in temperature.
• If you take the camera from a cold place to a

warm place, condensation may form on the lens
and internal parts (see “Condensation,” p. 37).

Do not point the lens at strong light

sources.
• Never point it at the sun, and do not leave it

aimed at a bright subject.

• Be especially careful when leaving the camera on

a tripod.

Avoid magnetic or electric fields.
• Do not use the camera close to power plants, TV

towers, TV sets, audio equipment or electric

motors as this may cause noise in the picture or a

camera malfunction.

Do not expose the camera to water.

• Use a rain shield when you are recording in light

rain or mist.

• There is a risk of electric shock if water gets

inside the camera — contact qualified service
personnel as soon as possible.

Always replace the lens cap.
• Sand and dust can damage the lens — be

especially careful on windy days.

Handle the camera gently.

• Vibration or shock can cause damage.

Do not disassemble the camera.

• This is very dangerous as there is a risk of

electric shock — if the camera does not function
properly, take it to qualified service personnel.

Viewfinder

• To clean the viewfinder screen, use a

commercially available blower brush. First

remove the eyepiece:
Pull the finder out as far as the line

O

on the

lower side of the grip. Rotate it anticlockwise and
pull it off.

To attach it:
Align the triangular mark 0 on the finder with the

mark

0

on the upper side of the grip. Push it in

until it stops, rotate it clockwise, and then push it
in fully.

Camera body and lens

• Use a soft, dry cloth to clean the camera body or

lens. Never use chemically treated cloth or
volatile solvents such as paint thinner.

Video heads

• Clean the video heads only when necessary,

preferably using Canon’s CC-8 Video Head
Cleaning Cassette.

• Do not use a “wet-type” cleaning cassette as this

can cause damage.

Storage

If you do not intend to use the camera for some

time, store it in an area which is free of dust and

moisture, and where the temperature is no higher

than 30° C (86° F).
After storage, check each part and function of your
camera to make sure everything is still working
properly.

Note:

• These cautions also apply to cassettes.

Advertising