Canon E 700 - Manual (Page 31)

Pop-up Light
Replacing the bulb
(A C
O
The pop-up light allows you to make clear
recordings of poorly lit indoor scenes. You can
even record in complete darkness.
1. Place the camera in record pause mode.
2. Slide the POP-UP LIGHT switch to make
the light pop up and turn on.
• The light will only turn on during recording or
in record pause mode.
3. Make your recording.
4. When you have finished using the light,
push it back into place.
• The light turns off automatically.
Use a Canon Halogen Bulb MHL-5.7V 4W.
1. Turn the camera off and give the bulb
time to cool down.
2. Remove the bulb protector as shown.
• Use a flat-edge screwdriver to loosen the
screw.
3. Pull out the old bulb and gently Insert
the new one as shown.
• Do not touch the new bulb (or the protector)
with your bare hands — use a soft cloth.
4. Replace the bulb protector.
• Don’t forget to tighten the screw.
■o
a
o
c
(0
>
■o
<
WARNING
Be careful not to touch the bulb during or
immediately after use; it becomes very hot.
Notes:
• Make sure that the whole of the scene is
illuminated during wide-angle recording.
• The light has a range of about 2 metres ( 6 V 2 feet).
• The BP-E77K Battery Pack provides enough
power for about 25 minutes’ use.
• The light becomes hot during use — keep it away
from plastic or flammable materials, and do not
touch it.
• Do not knock the light, especially during use.