Losi LOSB0289 Drift R Manual - Manual (Page 12)

48
28
41
47
43
49
BAG C (Continued)
Figure 20
Figure 21
Figure 21
Figure 20
9
"
Step 7. Thread a 3/16" ballstud (43) into the small hole of the
draglink (48) as indicated in Figure 20.
"
Step 8. Insert a carrier/ steering bushing (47), into the larger holes,
from the bottom side of the draglink (48). With the steering bushings
(47) in place, slide the draglink (48) through the steering tunnel (28)
and rest it on the left and right bellcranks (41), (42).
"
Step 9. Thread a 4-40 x 3/8" button head screw (49) through the
steering bushing (47) into the left bellcrank (41). Repeat for the right
bellcrank (42).
The steering assembly should rotate freely. Be sure that the
screws are not too loose but, not too tight.
43 47 49
All standard servos should use only one silver spring and one
gold spring. All hi-torque & high-speed servos will use all three
springs.
"
Step 10. Using Table 21B (on the following page), determine which
servo saver base (50) is required for your servo. If your particular
servo is not listed, try using the arm recommended for another servo
made by the same manufacturer.
"
Step 11. Thread a 3/16" ball stud (43) into the outer servo saver
arm (53) from the front side as indicated in Figure 21.
"
Step 12. Plug the servo into the radio system's receiver (not
included). Make sure that there is power to the receiver, and turn the
transmitter on followed by the receiver. Be sure that the trim settings
for the steering on your transmitter are set to the center. With the
radio system still turned on, attach the servo arm (50) to the output
shaft so that the arm is vertical as shown in Figure 21.
"
Step 13. Turn off your radio, slide one of the two "silver" servo
saver springs (4) over the servo arm which is connected to the servo.
Fit the second of the "silver" springs (4) over the first spring followed
by the "gold" spring (6). The springs should all be pressed against
the back of the servo saver base (50).
"
Step 14. Press the outer servo arm (53) into the servo saver base
(50). Insert the servo saver washer (54) into the outer servo saver arm
(53). Secure the assembly to the servo with the servo arm screw
supplied with the servo.
43
50
4
6
53
43
54