Losi LOSB0289 Drift R Manual - Manual (Page 29)

32
27
102
86
103
31
29
27
87
86
88
30
2 6
Figure 56
Figure 57
!
Step 1. Holding the car upside-down install the front bumper (87)
by lining up the holes in the fork of the front bumper (87) with the
holes in the chassis (27). It should rest on the front diff cover (29).
Secure the front bumper by threading two 4-40 x 1/4" flat head screws
(86) through the chassis (27) into the two holes in the back of the
front bumper (87) as indicated in Figure 56.
!
Step 2. Thread two 4-40 x 3/8" cap head screws (30) through the
front bumper (87) into the front diff cover (29).
!
Step 3. Thread the two 4-40 x 5/16" droop limiter set screws (88)
into the front bumper (87), until the hex of the screw (88) is positioned
half-way into the bottom of the bumper, as indicated in Figure 56.
You want to make sure that the droop limiter screws are even
on both sides of the car. The droop screws limit the down travel for
the arms. Refer to Tips from the Team in the back of the manual for
more information on Droop Screws!
Figure 56
30 86 88
!
Step 4. Install the rear bumper (102) by lining up the holes in the
fork of the rear bumper (102) with the holes in the back of the chassis
(27). Thread two 4-40 x 1/4" flat head screws (86) through the chassis
into the holes in the bumper as indicated in Figure 57 and tighten.
!
Step 5. Thread two 4-40 x 3/8" flat head screws (31) through the
bumper (102) into the rear diff cover (32) and tighten.
!
Step 6. Thread the two 4-40 x 7/16" droop limiter screws (103)
through the rear bumper (102), until the hex of the screw (103), is
positioned half-way into the bottom of the rear bumper (102) as
indicated in Figure 57.
Once again, you want to make sure that the droop limiter
screws are even on both sides of the car. The droop screws limit the
down travel for the arms. Refer to Tips from the Team in the back of
this manual for more information on Droop Screws!
31 86 103
Figure 57
BAG H