Losi LOSB0289 Drift R Manual - Manual (Page 13)

BAG C (Continued)
Figure 22
Figure 22
WIDE
NARROW
Table 21A
Table 21B
10
"
Step 15. Use Tables 21A and 21B to determine how the servo
mounting posts (55), (56) should be attached to the servo (not
included) in the Wide or Narrow position.
"
Step 16. Place a #4 washer (37) over each of the four 4-40 x 3/8"
button head screws (49) and attach the servo posts (55), (56) to the
servo by threading a screw (49) through the servo mounting ears into
the upper and lower holes in each post (55), (56). Do not tighten the
screws (49) yet! Just snug them up so that the posts are held in place,
but can still be moved from side to side with a little resistance.
"
Step 17. As shown in Figure 22, you will use the chassis to deter-
mine the exact spacing needed for your brand servo. With the scerws
(49) still loose, push the pins on the servo mounts (55), (56) into the
holes in the bottom of the chassis (27). Slide the mounts until the
screws (49) are centered on the servo, and tighten as indicated in
Figure 22.
The servo should be as close to centered between the two posts
as possible.
37 49
BASE
27
55
56
37
49
Note: If you wish to use Futaba
or HiTech Radios you will
need LOSA1540