Losi LOSB0289 Drift R Manual - Manual (Page 27)

92
110
122
121
114
123
66
63
110
122
121
114
120
66
BAG F (Continued)
24
Figure 54
Figure 54
Figure 55
Figure 55
!
Step 20. Position the bottom of an assembled rear shock in front
of the shock mounting area on the left rear suspension arm (92) as
shown in Figure 54. Align the hole in the shock mount ball (110) with
the outside hole in the arm (92).
!
Step 21. Attach the shock to the rear arm (92) by threading a 4-40
x 1/2" cap head screw (122) through the shock mount ball (110) and all
the way into the outside hole of the suspension arm (92).
!
Step 22. Slide a "long" shock mount bushing (123), large side
first, over the screw (66) on the left side of the tower.
!
Step 23. Place the top of the shock body (114) over the shock
mount bushing (123). Secure the shock to the tower by threading a
4-40 locknut (121) onto the shock mount screw (66).
Before attaching the top of the shock, make sure that the
dogbone is in place in the outdrive.
!
Step 24. Repeat Steps 20-23 for the right rear shock assembly.
121 122 123
!
Step 25. Position the bottom of an assembled front shock in front
of the shock mounting area on the left front suspension arm (63) as
shown in Figure 55. Align the hole in the shock mount ball (110) with
the middle hole in the arm (63).
!
Step 26. Secure the shock to the arm (63) by threading a 4-40 x
1/2" cap head screw (122) all the way into the arm (63) from the front.
!
Step 27. Slide a "short" shock bushing (120), large side first, over
the screw (66) on the left side of the front shock tower.
!
Step 28. Place the top of the front shock body (114) over the
shock mount bushing (120) on the tower. Secure the shock assembly
to the tower by threading a 4-40 locknut (121) onto the shock mount
screw (66).
!
Step 29. Repeat Steps 25-28 for the right shock assembly.
Once again, before attaching the top of the shock, make sure
that the dogbone is in place in the outdrive.
120 121 122